PRODUCT

Contact us

Name:Helen.

Tel:+86-755-82720811

E-mail:helen@chinalctech.com

Add:Room 301,Building No.3,Guole Technopark,Lirong Road,Dalang Street,Longhua District,Shenzhen 518110,China.

Online consulting

Other Module

Position:Home > Product > Module Series > Other Module >

CH344Q USB to Quad TTL Serial Module 4-way serial UART multi

a) About


The LC USB to four TTL serial port module is developed based on the CH344Q chip, which can convert one USB interface into four UART serial ports. It has a Type-C 5V DC input, built-in LED indicator light, a 500mA fuse on the input board, and supports overcurrent protection. It uses PH2.0 horizontal patch terminals and has the characteristics of overcurrent protection, high performance, low power consumption, and low cost.

b) View


①Front view




②Side view



③Reverse image



c)  Functional Features


 Supports USB to four-way UART conversion
 The output terminal adopts PH2.0 horizontal patch terminal
 Equipped with power indicator light and four-way UART signal indicator light
 Input end board mounted 500mA fuse, supporting overcurrent protection


d)  Introduction and Explanation


Board size:45*60mm/12 g




Interface Introduction



① USB port
② 500mA fuse
③ Serial port
④ Power indicator light
⑤ Chip: CH344Q
⑥ Serial port indicator light

Parameter:

Input voltage: 5V DC
Input interface type: USB Type-C
Output type: TTL UART serial port, a total of four channels
Output terminal specification: PH2.0 horizontal patch terminal
Overcurrent protection: 500mA fuse
Chip model: CH344Q
Indicator lights: power indicator light, four-way UART signal indicator light


e) Instructions for use


1. Install USB drivers on the computer;
(Official driver download website :https://www.wch.cn/downloads/USBMSER_exe.html
2. Connect the input end to the computer USB port, and connect the TX and RX of the output end with jumper caps. At this time, the LED power indicator light will light up;



3. At this point, open the USB device viewer or the built-in device manager on the computer, which will display information about the USB device and four COM ports





4. Open the serial debugger, select one of the serial port numbers, choose the appropriate baud rate, open the serial port and send the data. The window will receive the data without packet loss, as shown in the following figure: